Osburn AC02582 Bedienungsanleitung PDF herunterladen (Seite 3)

6. Release the exible hose from the air intake duct. A Small

amount of ash may be generated so be carefull (see 6

following).

7. Verify ash is cold! Allow to cool further if needed, then dump

debris. Ash is a great garden supplement!

Every 3 to 5 uses, clean HEPA lter while outside and away

from valuables. Screw o the lter wing nut and HEPA seal

plate (not shown). Take the lter out for cleaning (see step

below) or change. Follow the three steps below for taking o

the lter.

9. Cleaning lter - to limit dust place HEPA lter inside a plastic

bag (not included). To clean lter, tap gently against a hard

surface. Empty plastic bag and inspect lter. Dust within

the lter pleats may require gentle exing of the lter by

squeezing the lter’s rubber seals so as to make the lter oval

instead of round. Tap lter while “Out of round” to get deeply

set dust out of pleats.

Follow steps below for re-assembly of the lter :

10. IMPORTANT - with lter installed and lid in place turn

vacuum on at a dry outside location to test lter seal. Look

for dust at the exhaust port. A small amount is normal after

cleaning lter. Vacuum up a small amount of ash while still

outside to give nal assurance of a good seal and to verify

lter integrity. Replace lter if dust passes though at this point.

INSTRUCTIONS FOR USE

IMPORTANT NOTES:

* Each use, verify that HEPA lter is in place and that HEPA seal plate

wing nut is tight. Always test seal by vacuuming up a small amount of

ash while located away from living areas

** Do not attempt to use vac to remove large piles of ash from a replace

or wood stove. Instead remove bulk of ash with a shovel and ash can

(or hod) and then use the ash vac for nal cleanup.

1. Plug cord into outlet, (see photo 1 bellow).

2. Press the on/o button to switch the appliance on (see photo

2 bellow).

3. For replaces and wood burning stoves see “important

note **”, above. Place nozzle in rebox. Keep nozzle pressed

against the at surfaces of stove or replace to limit entrance

of large chunks into pickup tube. Use the built-in vibrating

lter cleaning feature after approximately each 1 cup of ash

is removed or when suction is reduced. Shaker instructions

are below. If large chunks are picked up, turn o machine to

dislodge.

HOW TO USE THE BUILT-IN VIBRATING FILTER CLEANING

FEATURE

When the suction is reduced or after about 1 cup of ash has been

removed use the vibration knob to help remove ash from lter

without taking o the lid.

A. Turn o machine!

B. Hold can down and retract shake o knob fully.

C. Release so knob bangs top lid.

D. This will send vibrations through the top lid to the lter to

help clear debris. Repeat 5 to 10 times. Suction should now

improve at star-tup.

4. When nished cleaning turn switch o, photo (see photo 4

following) .

5. Remove the plug from the outlet (see 5 following) and take

vacuum to an outside location away from valuables and

breezes.

6. Do not pull or carry by cord, use cord as a handle, close lid

on cord, or pull cord around sharp edges or corners. Do not

run vacuum cleaner over cord. Keep cord away from heated

surfaces.

7. When you want to pull the plug from the wall contact, please

do this at the plug itself and not by means of the electrical

cable.

8. Do not handle plug or vacuum cleaner with wet hands.

9. Do not put any object into openings. Do not use with any

opening blocked. Keep exhaust free of dust, lint, hair and

anything that may reduce airow.

10. Keep hair, loose clothing, ngers and all parts of body away

from openings and moving parts.

11. Turn o all controls before unplugging.

12. Use extra care if used when cleaning stairs.

13. Do not use to pick up ammable or combustible liquids, such

as gasoline, or use in areas where they may be present.

14. Hold plug when rewinding onto cord reel. Do not allow plug

to whip when rewinding.

15. Unplug before connecting the hose.

16. Do not pick up hot embers, hot ash or anything that is burning

or smoking, such as cigarettes or matches.

17. Do not use without lter in place.

18. If the supply cord is damaged, it must be replaced by qualied

person in order to avoid a hazard.

SAVE THESE INSTRUCTIONS

WARNING  To reduce the risk of electric shock, this vacuum

cleaner has a polarized plug (one blade is wider than the other). This plug

will t in a polarized outlet only one way. If the plug does not t fully

in the outlet, reverse the plug. If it still does not t, contact a qualied

electrician to install the proper outlet. Do not change the plug in any way.

PRECAUTIONARY MEASURES

If the opening that sucks in the air or the suction pipe is

blocked, you should switch o the vacuum cleaner at once.

First clear the blocked substance before you attempt to start

the vacuum cleaner again.

1. Do not operate the vacuum cleaner too close to heaters and

items like radiators, cigarettes, etc.

2. Before you insert the plug into the wall contact, make sure

your hand is dry.

3. When you want to pull the plug from the wall contact, please

do this at the plug itself and not by means of the electrical

cable.

SPECIAL NOTE: THIS VACUUM’S MOTORS ARE EQUIPPED WITH THERMAL

“OVERHEAT” PROTECTION. IF THE MOTORS RUN TOO HOT THEN THEY

WILL SHUT DOWN. YOU MUST WAIT FOR MOTOR TO COOL AND UNPLUG

UNIT IN ORDER TO RE-START VACUUM. CLEANING THE FILTER WILL HELP

PREVENT A REPEAT OF THIS CONDITION.

Model #: AC02582

Voltage 120 V

Frequency 60 Hz

Power 800 W

Max Vacuum 17 Kpa

Sound Level Max <84 dB

Max Airow 85-CFM

TIGHTEN

WING NUT

SootStop Pre-lter extends the life of HEPA lter. Most helpful

with pellets stoves.

INSTALLATION - Start with a new

or cleaned HEPA lter, seal plate

and wing nut .Place elastic over

the seal plate and pull down.

Pull SootStop lter fully so the

elastic contacts the rubber part.

FILTER CARE: Filter may be washed or simply shaken out. Replace

if holes in fabric develop.

LOOSEN

WING NUT

NOTE: This process will be dusty. Pictures depict a clean machine

for illustrative purposes.

ASH

VACUUM

B C

4 5 6

AC02585_User guide.indd 3 10/25/2013 2:28:36 PM

1 2 3 4 5 6 7 8 ... 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Osburn AC02582 Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Osburn AC02582